Tag Archives: pins

Blinking LED Arduino project

This video tutorial has been designed for those just starting out with Arduino. For this beginner project you will need an Arduino Uno board (or compatible board), an LED of any colour, a 470-Ohm resistor, two jumper wires, a breadboard, a male A-B USB cable, and a computer (Mac/Windows) with the Arduino IDE software installed.

This project involves programming your Arduino Uno to make an LED light blink on and off. To get started, watch the video below or click here to view it on YouTube. Access the links below to get a copy of the code, printed instructions, schematic, and a guide to resistors.

Downloads:

The source code is also available here:

/*
 Blink
 Turns on an LED on for one second, then off for one second, repeatedly.
*/
 
// Give the LED a name - it will be connected on PIN 13
int led = 13;
 
// the setup routine runs once when you press reset:
void setup() { 
 // initialize the digital pin as an output.
 pinMode(led, OUTPUT); 
}
 
// the loop routine runs over and over again forever:
void loop() {
 digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
 delay(1000); // wait for a second (1000 = 1 sec.)
 digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
 delay(1000); // wait for a second
}

Photos

1 2 3 4